the main · Tips ·

How to wash a hand blender without cuts and dark coating

Submersible blender consists of a handle with a built-in motor and legs with a bell and chopper. How to wash the device so as not to cut yourself or damage the blender? Simple tips and a few warnings: use only water, dishwashing gel and a glass from a blender.

Hand blender

Regular care

The most important thing is to wash the submersible blender after each use, without waiting for the remaining food to dry. How to do it right:

  1. Fill a glass from a blender or other suitable container with warm, 40-60 degrees, water.
  2. Drip the dishwashing detergent, do not stir.
  3. Collect and connect a blender to the network.
  4. Lower your foot in water and turn on the device for 1-3 minutes.
  5. Turn off the device, unplug it and remove your leg.
  6. Rinse it under running water and place it upside down in the cutlery stand.

Drying the blender is not recommended, especially the knives: it is so easy to injure your fingers. Shake enough to get rid of the drops and leave to air dry.

cleaning blender

Complex pollution

If it happened that the blender had time to dry, and ordinary washing does not cope with pollution, it is worth soaking your foot. You do not need to use aggressive alkalis or acids, including Domestos, Sanita, etc.

Abrasive powders, brushes and metal sponges are not acceptable: the body and knives will cover the scratches, due to which food particles will be washed more and more difficult, and the device will become unhygienic.

Disassembled blender

To get rid of complex, dried-on food debris, just lower your foot in a warm solution of dishwashing gel and hold for about 20 minutes. Then wash in the usual way. It is permissible to rub the knives and case slightly with a brush or brush with a soft bristle brush. By no means with your hands!

Important
The magazine purityis.decorexpro.com/en/, having studied the issue, strongly does not recommend washing the foot of the submersible blender in the dishwasher. Aluminum and plastic parts will be damaged due to alkali in the detergent.

Blender on the table

What parts can not be washed

Under no circumstances should the handle, wire and plug be washed. If water gets into them, the device will be irreparably damaged.

If for some reason drops fall into the handle with the motor, it is necessary to immediately disconnect the device from the mains, it is advisable to loosen the screws, open the case, shake out the water and allow the parts to dry in air.

Blender parts

How to care for the handle and the wire: dry cleaning is preferable, using a microfiber cloth, it is permissible to wipe the case and wire with a wet cloth if the device is unplugged. The planned procedure is carried out once a month or less, depending on how often the blender is used.

A hand blender does not require much effort: to keep it clean, it is enough to rinse it after each use. And if fingerprints accidentally appeared on the handle, just wipe it with a damp cloth and the device will again be clean and aesthetically pleasing.

material author changes from
leave a comment

Cleaning

Wash

Stains